New Design Air To Water U-tube heat exchanger

New Design Air To Water U-tube Heat Exchanger

Product introduction

The main work points of U-tube heat exchanger

1. Cleaning the pipe: When installing and using the U-tube heat exchanger, it is necessary to ensure that the inside of the pipe is clean to avoid the influence of impurities and dirt in the pipe on the heat exchanger.Tubular Heat Exchanger,Efficiency Tubular Heat Exchanger,Tube In Tube Heat Exchanger

2. Check pipes: Check pipes regularly for damage or water leakage, and repair or replace damaged pipes in time.

3. Flow control: Adjust the inlet and outlet valves as required to control the flow to ensure the normal work of the heat exchanger.

4. Cleaning heat exchanger: regular cleaning heat exchanger, to avoid the influence of impurities and dirt inside the pipeline on the heat exchanger.

5. Maintain pipes: Check pipes regularly for corrosion and deformation, and maintain them in time.

6. Regular inspection: regularly check the performance and working state of the heat exchanger, timely find problems and maintenance.

Product parameter

Working pressure /MPa: -0.1~20

Operating temperature /℃: -40~350

Notes on heat exchanger

1. Clean heat exchanger: Regular cleaning of heat exchanger can maintain its efficient operation. Cleaning, should be careful not to use too strong cleaner or brush, so as not to damage the surface of the heat exchanger.

2. Maintain pipes: Pipes should be inspected regularly to ensure that there are no leaks or clogs. If a problem is found, repair or replace it in time.

3. Control water quality: Water quality is very important for the operation of heat exchanger. Impurities and hard substances in the water will form a scale layer inside the heat exchanger, reducing the heat transfer efficiency. Therefore, the water quality should be checked regularly and necessary measures should be taken to control it.

4. Control water flow: Water flow is also very important for the heat transfer efficiency of heat exchanger. Too high or too low water flow will affect the performance of heat exchanger. Therefore, the water flow should be adjusted according to the actual situation.

5. Regular inspection: regularly check the operation of the heat exchanger, including temperature, pressure, flow and other parameters. If any exception is found, handle it in time.

6. Safety operation: When operating heat exchanger, attention should be paid to safety. Safety regulations and operating procedures must be followed to avoid accidents.